Speed up your system by avoiding the swap file

Most modern operating systems are capable of using a file or partition known as a swap or paging file. Most Linux distributions will also install one for you by default. This file is used to extend the amount of available RAM by writing some of it to your hard drive.

There’s just one problem: hard drives are slow. We can’t fix that problem yet, but we can avoid it. The Linux kernel provides a tweakable setting that controls how often the swap file is used, called swappiness. A swappiness setting of zero means that the disk will be avoided unless absolutely necessary (you run out of memory), while a swappiness setting of 100 means that programs will be swapped to disk almost instantly.
Read more…

All about Linux swap space

As well as the swap partition, Linux also supports a swap file that you can create, prepare, and mount in a fashion similar to that of a swap partition. The advantage of swap files is that you don’t need to find an empty partition or repartition a disk to add additional swap space.

To create a swap file, use the dd command to create an empty file. To create a 1GB file, type:

dd if=/dev/zero of=/swapfile bs=1024 count=1048576

/swapfile is the name of the swap file, and the count of 1048576 is the size in kilobytes (i.e. 1GB).

Prepare the swap file using mkswap just as you would a partition, but this time use the name of the swap file:

mkswap /swapfile
Read more…